Information SET-01 59
DIGITAL plus
14.3.3.1 Additional settings that can be programmed and
read out with the “DIR” menu
Aside from the address, the “DIR” menu offers you a simple method
for programming the other key locomotive settings.
Press On the display you see Explanation
The most recently selected
menu is shown
(flashes)
The most recently selected
programming mode is shown
Page with ‘-’ until “DIR” is
displayed
First you are prompted to
read/write the locomotive
address.
The ‘+’ or ‘-’ key lets you page
through the other settings. “ACC”
stands for acceleration delay
(CV3).
“DCC” stands for deceleration
delay (CV4).
“STV” stands for starting
voltage (CV2).
“MAX” stands for maximum
speed (CV5). Please note that
not all decoders use CV5.
If you want to show the value of one of the settings (CVs), press
‘Enter’, when the setting is displayed,. To change the value key in
the desired value followed by 'Enter'. To read out the value in the CV
pressing ‘Enter’ without entering any new value. (the same as
reading and writing a locomotive address described previously).
To Next Page
Loading...