Lenz Digital plus SET-01/4 User Manual

70 Information SET-01
With the ‘-’ key you lower it.
While you are pressing the key,
the corresponding arrow is
shown in the display.
Each keystroke immediately
changes the contrast of the
display, so that you instantly can
evaluate the result of the
change.
'Enter' confirms the change, ‘Esc’
lets you leave the menu without
changing the setting.
You leave the system menu with
‘Esc’, which takes you back to
selecting the settings.
With another ‘Esc’ you return to
controlling locomotives.
15.2.4 SET_4: mode of counting bits in the display
The section “Setting and erasing bits” described how you can
change individual bits in CVs. When doing so, the bits are counted
starting with 1.
Some decoders from other manufacturers may start counting the
bits with 0. To make it easier be able to get a display corresponding
to this mode of counting, you can set the mode of counting for the
bit display in SYS_4.
To configure this setting go to the SET menu:
Press On the display you see Explanation
You reach this display by
pressing 'F' followed by '9'
followed by '1'.
The currently selected mode is
shown. (Mode of counting 1-8 is
factory default.)
With the ‘+’ (or ‘-’) key you can
change the setting of the mode of
counting.
'Enter' confirms the change, ‘Esc’
lets you leave the menu without
changing the setting.

Lenz Digital plus SET-01/4 Specifications

General

Brand	Lenz
Model	Digital plus SET-01/4
Category	Control Unit
Language	English