Lenz Digital plus SET-01/4 User Manual

Information SET-01 71
DIGITAL plus
You leave the system menu with
‘Esc’, which takes you back to
selecting the settings.
With another ‘Esc’ you return to
controlling locomotives.
15.2.5 SET_5: Erasing locomotive addresses from the
command station stack
As described previously, the LZ100 command station sends
operation data repeatedly to all locomotive addresses contained in
its stack.
If you fill the LZ100 locomotive stack you can erase locomotive
addresses that are not needed for operation from the stack. This
setting is user controllable.
FF You can only set this setting when using a command station
version 3 or higher.
FF To be able to erase locomotive addresses from the command
station stack, this system setting must be set to “CL ON”.
To configure this setting go to the SET menu:
Press On the display you see Explanation
You reach this display by
pressing 'F' followed by '9'
followed by '1'.
The current setting is shown. (Off
is the factory default.)
With the ‘+’ (or ‘-’) key you can
change the setting.
'Enter' confirms the change, ‘Esc’
lets you leave the menu without
changing the setting.
You leave the system menu with
‘Esc’, which takes you back to
selecting the settings.
With another ‘Esc’ you return to
controlling locomotives.

Lenz Digital plus SET-01/4 Specifications

General

Brand	Lenz
Model	Digital plus SET-01/4
Category	Control Unit
Language	English