Lenze 8400 - Properties; Terminals and Interfaces

EDS84AYCER EN 2.0 - 11/2010 L 15
E84AYCER communication manual (PROFINET)
Product description
Properties
3.3 Properties
 Interface module for the PROFINET communication system to be secured to the
expansion slots of the Inverter Drives 8400
 The communication module can either be supplied internally by the standard device or
externally by a separate voltage source.
 Support of the I&M0...4 functionality for the identification of the standard device
 Automatic detection of the baud rate 100 Mbps
 A line topology is enabled by the integrated 2-port switch.
 Support of the LLDP protocol for the topology recognition
 Support of the SNMP protocol for diagnostic purposes
 Access to all Lenze parameters
3.4 Terminals and interfaces
 2 RJ45 sockets for the PROFINET connection
 2-pole plug connector for the external voltage supply of the communication module.
 Front LEDs for diagnosing the ...
– Voltage supply of the communication module;
– Connection to the standard device;
–PROFINET connection;
– PROFINET activity.
[3-2] E84AYCER communication module (PROFINET)
E84YCER001C
X255 External voltage supply of the communication
module
• 2-pole plug connector with spring
connection
External voltage supply
( 32)
X256 PROFINET input (IN)
X257 PROFINET output (OUT)
• RJ45 sockets
• Each with 2 LED status displays for
diagnostics
Network topology
( 26)
PROFINET connection
( 28)
Status displays at X256 and X257
( 69)
MS
ME
BS
BE
DE
5 LED status displays for diagnostics
Module status displays
( 67)
Fieldbus status displays
( 68)