24 M301L
13 KEYPAD CONTROL
The drive can be operated in a number of different ways: keypad (LOCAL), control devices
wired to the terminal strip (REMOTE), serial communications (SERIAL), or combinations
of each. The drive should first be operated from the keypad during initial start-up. Refer
to Sections 14 - CONTROL WIRING, and 18 - DESCRIPTION OF PARAMETERS for
information on remote operation.
13.1 KEYPAD FUNCTIONS
START/STOP To start the drive, press the START key. To stop the drive, press
the STOP key.
NOTE 1: A jumper may need to be installed between TB-1 and
TB-2 in order to START the drive in LOCAL mode
(refer to Parameter 30 - CONTROL).
NOTE 2: The STOP key is active in both LOCAL and REMOTE
modes.
SPEED SETPOINT To increase the speed setpoint, press the key. To decrease
the speed setpoint, press the key.
NOTE: The and keys are only active if another speed
reference source is not selected.
LOCAL/REMOTE To toggle between LOCAL and REMOTE mode, press the
LOCAL/REMOTE key to select the desired mode, and then press
the ENTER key within three seconds to confirm the change.
NOTE: Parameter 30 - CONTROL must be set to KEYPAD
or KEYPAD 2 for this key to be active.
AUTO/MANUAL To toggle between AUTOMATIC (terminal strip) and MANUAL
(keypad) speed control, press the AUTO/MAN key to select
the desired mode, and then press the ENTER key within three
seconds to confirm the change.
NOTE: Parameter 28 - AUTO/MAN must be set to A/M LOC
or A/M SPD for this key to be active. Refer to Section
14 - CONTROL WIRING for information on automatic
speed reference sources.
FAULT RESET Use the STOP key to reset a fault. If the fault condition has
passed, pressing the STOP key will clear the fault and return
the drive to a STOP condition.
NOTE: If an OUTPUT fault occurs, there will be a 30 second
delay before the fault can be cleared using the STOP
key.
To Next Page
Loading...
