Need help?Do you have a question about the Lenze AC Tech SC Series and is the answer not in the manual?
Covers general, application, and installation safety precautions for drive controllers.
Step-by-step guide for serial control of start/stop, speed, and parameter changes.
Instructions for Start/Stop control, drive unlocking, and setting manual mode for network operation.
Basic commands for STOP, START, direction changes, and speed control via Modbus registers.
Describes SCF Drive Control Registers, their order, R/W status, message format, and units.
Explains reading Registers #24-29 for drive status, covering command speed and actual speed.
Lists initial SCF drive parameters: Line Voltage, Carrier Frequency, Start/Stop Method, Speed Source, and Outputs.
Lists SCF drive parameters for TB-13A/B/C Input, TB-15 OC Output, and Control settings.
Lists SCF drive parameters: Serial Link, Units Editing, Rotation, Acceleration/Deceleration, DC Brake.
Lists SCF drive parameters: Frequency limits, Current Limit, Overload, Boost, Slip Compensation, Preset Speeds.
Lists SCF drive parameters: Skip Frequency, Bandwidth, Speed/Load Scaling, Accel/Decel #2, Serial Address.
Lists SCF drive parameters: Password, Clear History, Program Selection, Fault History, Software Version.
To Next Page
General