The information given in this Manual applies to the below Lenze PLCs:
Automation system Type as from hardware version as from software version
9300 Servo PLC EVS93XX-xI 2K 2.0
9300 Servo PLC EVS93XX-xT 2K 2.0
Drive PLC EPL10200 Px 2.0
Important note :
The software is supplied to the user as described in this document. Any risks resulting from its quality or use remain the responsibility of the
user. The user must provide all safety measures protecting against possible maloperation.
We do not take any liability for direct or indirect damage, e.g. profit loss, order loss or any loss regarding business.
E 2001 Lenze GmbH & Co KG
No part of this documentation may be copied or made available to third parties without the explicit written approval of Lenze GmbH & Co KG.
All information given in this online documentation has been carefully selected and tested for compliance with the hardware and software
described. Nevertheless, discrepancies c annot be ruled out. We do not accept any responsibility or liability for any damage that may occur.
Required corrections will be included in updates of this documentation.
Windows, Windows NT and MS-DOS are either registered trademarks or trademarks of Microsoft Corporation in the U.S.A a nd/or other coun-
tries.
IBM and VGA are registered trademarks of International Business Machines, Inc.
All other product names are trademarks of the corresponding owners.
Version 1.1 07/2001 - TD11
To Next Page
Loading...
