Lenze E82MV152_4B

Table of keywords
abc
15−3
L EDB82MV752 EN 5.2
Digital output signal PCTRL1−LIM, 14−27
Digital output signal PCTRL1−SET=ACT, 14−27
Digital outputs, 14−48
digital outputs, 7−76
Deceleration, 7−24
Deceleration time
Additional setpoint, 7−24 , 14−26
Process controller setpoint, 14−27
Deceleration times, 7−24
Default setting
load, 7−91 , 14−11
Restorage, 7−91 , 14−11
Definitions, Terms, 1−1
Degree of pollution, 3−1
Delay digital outputs, Application I/O, 14−48
Delay of digital outputs, application I/O, 7−76
Derating, 7−14 , 7−16 , 7−23
Design, mechanical, 4−1
Device protection, 2−5
Diagnostics, 7−86 , 7−89 , 14−25
Digital input signals, 7−68
Digital inputs
Level inversion, 7−72 , 14−37
level inversion, 14−21
Digital output signals, 7−73
Digital outputs
Configuration, 7−73
Level inversion, 14−41
level inversion, 7−76
digital switching output, linking with internal digital signals,
7−73
Dimensions, 4−2
Direction of rotation
Failsafechange, 7−28
Nonfail−safe change, 7−28
dismounting, function module, 4−8
Display
Application datum, 7−86
bar graph, 6−3
keypad, 6−2
Operating status, 8−1
Software version, 7−89 , 14−18
status, 6−3
Type, 7−89 , 14−18
Display functions, 7−86
Possible values, 7−86
Display of operating data, 7−86
Display values, 7−86
Calibration, 7−86
Drive performance
at mains disconnection, 7−18
at mains failure, 7−18
Controller inhibit, 7−20
Controller inhibit/controller release, 7−18
in case of errors, 8−2
Dry running protection, 7−21
E
E82ZBC keypad, Changing and saving parameters, 5−3
Earth fault, Detection, 7−84
Earth fault detection, 7−84
Earth−leakage circuit breaker, 4−5
operation with, 4−5
Electrical installation, 4−3
according to EMC, 4−7
important notes, 4−3
EMC, 3−2
Emergency off, Controller inhibit, 7−20
EN 61000−3−2, 4−4
Enclosure, 3−2
Error analysis, 8−1
Error elimination, 8−3
Error message, Reset, 8−7
Errors, external fault evaluation, 7−85
F
Fault elimination, 8−1
Fault message, External, 7−85
Fault message reset, , 7−85
Fault messages, 8−4
Field frequency
maximum, 7−21
Minimum, 7−21
FIF, 1−1
Fixed frequencies (JOG), additional, 7−43 , 14−49
Fixed setpoint (JOG), 7−43
Flying restart circuit, 2−5
Flying−restart circuit, 7−18
Free space, 3−1
Frequency, Skipping, 7−17
Frequency input
Automatic adjustment, 7−40 , 14−49
digital, 7−39