8400 StateLine C | Operating instructions
Before commissioning
General notes on applications
22 L from Firmware V06.00 - DMS 1.1 EN - 11/2011
5.3 General notes on applications
The technology applications integrated in the drive controller provide the main signal flow
for the implementation of a general or a special drive solution.
Basic components of a drive solution
A drive solution consists of the following basic components:
Signal inputs (for control and setpoint signals)
Signal flow of the technology application
Signal outputs (for status and actual value signals)
[5-4] Basic components of a drive solution
Technology application "Actuating drive speed"
This technology application preset in C00005 serves to solve speed-controlled drive tasks,
e.g. conveyor drives (interconnected), extruders, test benches, vibrators, travelling drives,
presses, machining systems, metering units.
"Switch-off positioning" technology application
This technology application to be selected in C00005 is used to solve speed-controlled
drive tasks which require a pre-switch off or stopping at certain positions, e.g. roller
conveyors and conveying belts.
Detailed information on each application can be found in the software manual
of the 8400 StateLine in the "Technology application" chapter.
M
...
M
n
t
è
ç
Switch-off positioning
Actuating drive speed
Setpoint
generator
Process
controller
Motion
Control
Kernel
Device
control
Motor
control
Signal
inputs
Signal
outputs
To Next Page
Loading...
