Lenze E84AVSC - Process Controller

from Firmware V06.00 - DMS 1.1 EN - 11/2011 L 69
8400 StateLine C | Operating instructions
Adapting the application individually
Implementing more additional functions in the signal flow
8.3.3 Process controller
The process controller can be used as PID controller for various control tasks (e.g. as dancer
position controller, tension controller or pressure controller).
 The process controller is provided with the following functions:
– Adjustable control algorithm (P, PI, PID)
– Ramp function generator for preventing setpoint step-changes at the input
– Limitation of the controller output
– Factorisation of the output signal
– Vp adaptation
– Integral action component can be switched off
– Comparison function "Actual value = setpoint"
 In the Lenze setting, the process controller is deactivated.
 The process controller is activated by selecting the operating mode in C00242.
 Configuration parameters serve to link the inputs of the process controller to the
required process signals.
/$B1&WUO
E6HW(T$FW
E,2II
Q$FWBD
E,Q$FW
E(QDEOH,QIOXHQFH5DPS
Q,QIOXHQFHBD
Q2XWBD
Q16HWBD
Q6HWBD
Q$GDSWBD
&
&
&
&
&
&
&
&
&7Q
&9S
&.G
___
_
_
___


&
___
_
Q,6HWBD
&
Q3,'2XWBD
Q3,'2XWBD
Q,QIOXHQFH2XWBD
E,6HW
/B3&75/B
&
E3,'2II
&
Q3,'9S$GDSWBD
Q3,'6HW9DOXHBD
Q3,'$FW9DOXHBD
E3,',2II
E3,'(QDEOH
,QIOXHQFH5DPS
Q3,',QIOXHQFHBD
&
&
&
&
&
&