Lenze E84AVSC - Before Commissioning; Selection of the Appropriate Commissioning Tool

from Firmware V06.00 - DMS 1.1 EN - 11/2011 L 13
8400 StateLine C | Operating instructions
Before commissioning
Selection of the appropriate commissioning tool
5 Before commissioning
Being a component of a machine which includes a speed-variable drive system, the
controller needs to be adjusted to its drive task. The controller is adjusted by changing
parameters which are saved in the memory module. The parameters can be accessed by
keypad, by the L-force »EASY Starter« or by the L-force »Engineer«. Access is also possible
by a master control via fieldbus communication, e.g. via CAN bus.
5.1 Selection of the appropriate commissioning tool
There are several possibilities for commissioning the 8400 StateLine controller:
 Danger!
In general, changing a parameter causes an immediate response in the
controller!
This may lead to undesirable behaviour on the motor shaft if the controller has
been enabled! Setpoint sources, for instance, may switch over all of a sudden
(e.g. when configuring the signal source for the main setpoint).
Certain device commands or settings which may cause critical states of drive
behaviour constitute exceptions. Such parameter changes are only possible if
the controller is inhibited. Otherwise, a corresponding error message will be
issued.
Commissioning with keypad X400 (diagnosis terminal X400)
The keypad is an alternative to the PC for the local operation, parameterisation, and
diagnostics in a simple manner. The keypad is especially suitable for test or demonstration
purposes and if only a few parameters have to be adapted.
Commissioning with PC and L-force »EASY Starter«
The L-force »EASY Starter« is a Lenze tool for easy online diagnostics, parameter setting
and commissioning of the controller.
Commissioning with PC and L-force »Engineer«
The L-force »Engineer« is a Lenze engineering software for parameter setting across all
devices, configuring and diagnosing individual components (as for instance controllers,
industrial PCs, motors, I/O systems) and machine control systems.