Lenze E84AVSC - Implementing More Additional Functions in the Signal Flow

from Firmware V06.00 - DMS 1.1 EN - 11/2011 L 63
8400 StateLine C | Operating instructions
Adapting the application individually
Implementing more additional functions in the signal flow
8.3 Implementing more additional functions in the signal flow
The pre-assignment of the application can be reconfigured via configuration parameters.
Thus, additional functions can be implemented in the signal flow as well.
Please observe the "source/destination principle" in this connection:
 A device input terminal can be linked to several input interfaces of the application.
 Each input interface of the application can only be linked to one input signal.
 An output interface of the application can be linked to several device output terminals.
The following subchapter "Pre-assignment of the input and output interfaces
" shows in
detail the configuration parameters for the "actuating drive speed" application.
$SSOLNDWLRQ
$QWULHEVVFKQLWWVWHOOH
,QSXWV
,QSXWSRUWV
2XWSXWSRUWV

$SSOLFDWLRQ
'LJLWDOLQSXWV 'LJLWDORXWSXWV
$QDORJLQSXWV
,QSXWV
2XWSXWV
$QDORJRXWSXWV
& &
& &