8400 StateLine C | Operating instructions
Adapting the application individually
56 L from Firmware V06.00 - DMS 1.1 EN - 11/2011
8 Adapting the application individually
This chapter describes further adaptation options of the application based on the
respective function block interconnection.
Further functions that are first deactivated by default (e.g. ramp smoothing for the
main speed setpoint, speed limit values and speed blocking zones) can be activated in
the main signal flow through parameter setting.
Moreover, the assignment of inputs and outputs can be reconfigured via configuration
parameters to e.g. use the process controller or the motor potentiometer sensibly.
To Next Page
Loading...
