Lenze E84AVSC - Parameter Change-Over

from Firmware V06.00 - DMS 1.1 EN - 11/2011 L 73
8400 StateLine C | Operating instructions
Adapting the application individually
Implementing more additional functions in the signal flow
8.3.4 Parameter change-over
For up to 32 freely selectable parameters, the basic function "parameter change-over"
provides a change-over between four sets with different parameter values.
 The value set to be used is selected binary-coded via the selection inputs
bSelectWriteValue_1 and bSelectWriteValue_2 of the SB LS_WriteParamList.
 The writing of the parameter list is activated by a FALSE/TRUE edge at the bExecute
control input.
In the following example, the control inputs of the parameter change-over are linked to
the free parameters C00470/1...3 by parameterising the respective configuration
parameters (C00621/x):
[8-2] Example: Linking the control inputs of the parameter change-over to "free" parameters
E'RQH
E6HOHFW:ULWH9DOXHB
E([HFXWH
E6HOHFW:ULWH9DOXHB
)$/6(
)$/6(
,QGH[
9DOXH 9DOXH 9DOXH 9DOXH
,QGH[ 9DOXH 9DOXH 9DOXH 9DOXH
,QGH[
9DOXH 9DOXH 9DOXH 9DOXH
   
,QGH[Q 9DOXHQ 9DOXHQ 9DOXHQ 9DOXHQ

758(
)$/6(
)$/6(
758(
758(
758(
9DOXHV6HW 9DOXHV6HW 9DOXHV6HW 9DOXHV6HW
3DUDPHWHUOLVW
&75/
E)DLO
)DLOVWDWH
)DLOOLQHQXPEHU
)RUPDW&RGHQXPEHU!6XEFRGHQXPEHU!
/6B:ULWH3DUDP/LVW
&
&
&
&
&
&Q
&
&
&
&Q
&
&
&
&Q
&
&
&
&Q
&
&
&
&Q
E3DU
E3DU
E3DU
E3DU
E3DU
&
&
&
&
&
/6B3DU)UHHBE
E3DU
E3DU
E3DU
&
&
&