Lenze E84AVSC - Diagnostics and Troubleshooting; LED Status Displays for Device Status

from Firmware V06.00 - DMS 1.1 EN - 11/2011 L 45
8400 StateLine C | Operating instructions
Diagnostics & troubleshooting
LED status displays for device status
7 Diagnostics & troubleshooting
7.1 LED status displays for device status
The control of the two LEDs "DRV-RDY" and "DRV-ERR" in the lower
part on the front of the controller depends on the device status.
For the meaning please refer to the following table:
DRV-RDY DRV-ERR Description Device status
(Display in C00137)
OFF OFF OFF or initialisation active Init
OFF Safe torque off is active SafeTorqueOff
OFF Device is ready to start ReadyToSwitchOn
OFF Device is switched on SwitchedOn
OFF Motor data identification/operation OperationEnabled
The controller is ready to switch on, switched on or the operation is
enabled and a warning is indicated.
Fault active, quick stop TroubleQSP
OFF Trouble is active Trouble
OFF Fault is active Fault
OFF System fault is active SystemFault
Legend
The symbols used for indicating the LED states have the following meaning:
LED is flashing once approx. every 3 seconds (slow flash)
LED is flashing once approx. every 1.25 seconds (flash)
LED is flashing twice approx. every 1.25 seconds (double flash)
LED is blinking every second
LED is permanently on
'595'<
&$1581
'59(55
&$1(55