from Firmware V06.00 - DMS 1.1 EN - 11/2011 L 5
8400 StateLine C | Operating instructions
About this documentation
1 About this documentation
This documentation applies to the 8400 StateLine C controller with the following
nameplate data:
The documentation contains important technical information on how to commission
and operate the 8400 StateLine C controller.
The documentation applies to the "simple" "speed-controlled" operation preset by
Lenze by default. The most important settings for commissioning will be explained so
that many applications using the 8400 StateLine C controller and the preset
application "actuating drive speed" can be solved quickly.
The documentation supplements the mounting instructions, the hardware manual
and the software manual for the 8400 StateLine C controller.
The hardware and software manual are included in the scope of supply. in electronic
format.
Definition of the notes used
The following signal words and symbols are used in this documentation to indicate
dangers and important information:
Product range Type designation from software version
8400 StateLine C E84AVSCxxxxx 06.00
Symbol Signal word Meaning
Danger! Danger of personal injury through dangerous electrical voltage
Reference to an imminent danger that may result in death or serious personal injury
if the corresponding measures are not taken.
Danger! Danger of personal injury through a general source of danger
Reference to an imminent danger that may result in death or serious personal injury
if the corresponding measures are not taken.
Stop! Danger of property damage
Reference to a possible danger that may result in property damage if the
corresponding measures are not taken.
Note! Important note to ensure trouble-free operation
To Next Page
Loading...
