Installation
Installation of 8400 motec pre-assembled on the motor
Plug at the Wiring Unit
5
66
EDS84DG752 EN 5.0
5.7 Installation of 8400 motec pre-assembled on the motor
The worksteps to be done during the installation of pre-assembled 8400 motec controllers
depend on the selected connection type of the Wiring Unit:
ƒ Plugs
ƒ Cable gland (M25)
5.7.1 Plug at the Wiring Unit
The motor has already been wired with the Wiring Unit by the manufacturer. Make sure
that the plug assignment of the mains cable complies with the plug at theWiring Unit. You
must plug on and lock the mains cable with the suitable plug.
To Next Page
Loading...
