Lenze ECS series User Manual

Index15

482
EDBCSXA064 EN 3.2
TRIP status, 329
− DCTRL_DriveControl (device control), 329
TRIP−RESET, 238 , 254
Troubleshooting
− fault analysis with history buffer, 237
− fault messages, 242
− malfunction of drive, 241
Troubleshooting and fault elimination, 236
− monitoring
current load of the motor (I2 x t monitoring), 32 , 214
voltage supply of control electronics, 221
− monitoring functions
bus off, 203
current load of controller (I x t monitoring), 211
DC−bus voltage, 218
earth fault, 205
heatsink temperature, 208
max. system speed, 227
monitoring times for process data input objects, 202
motor phase failure, 221
motor temperature, 206
motor temperature sensor, 223
Resolver cable, 222
rotor position adjustment, 228
short circuit, 205
sin/cos signal, 225
speed system deviation, 226
temperature inside the controller, 209
thermal sensors, 210
TTL encoder, 98
TTL incremental encoder, as position and speed encoder,
115
U
Undervoltage threshold, DC−bus voltage, 218
User data, 441 , 453 , 455
V
Vibration resistance, 40
Voltage supply of control electronics, monitoring, 221
W
Warning, 197
Warranty, 20
Wiring, system bus (CAN), 92
X
XCAN sync identifier, 190
XCAN sync response, 190
XCAN Sync Tx transmission cycle, 191
XT EMZ9371BC keypad, Diagnostics, 232

Lenze ECS series Specifications

General

Brand	Lenze
Model	ECS series
Category	Control Unit
Language	English