Index 15
481
EDBCSXA064 EN 3.2
System bus (CAN), 375 , 440
− assignment of the plug connectors, 91
− baud rate, 93 , 94
− CAN_Synchronization, 281
− CANaux1_IO, 303
− CANaux2_IO, 309
− CANaux3_IO, 314
− cycle time, AIF interface, 188
− cyclic process data objects, synchronisation, 450
− defining the instant of transmission for
CAN2/CAN3_OUT, 279
− determining the master in the drive system, 162
− event−controlled process data objects, 451
− identifier, 441 , 458
AIF interface, 185
− Individual addressing, 160
− Interfaces for system bus connection, Configuration of
CAN bus interfaces, 155
− interfaces for system bus connection, configuring the AIF
interface, 182
− making a reset node, 165 , 279 , 301
− monitoring, AIF interface, 192
− network management data, 441
− parameter data, 441 , 452
− parameter data channels, 452
− process data, 441
− process data objects, 445
addressing, 458
data transmission, 448
− process data telegrams, 446
− reset node, AIF interface, 191
− setting delay time, 163
− setting the baud rate, 155
− setting the cycle time, 163
− setting the node address, 155
− status messages, 280 , 302
− user data, 441 , 453
− wiring, 90 , 92
system bus (CAN)
− CAN data telegram, 441
− parameter data objects, addressing, 458
System bus components, 461
System error messages, Causes and remedies, 246
System program organisation units, 383
System variables, 23
SYSTEM_FLAGS, 372
− Inputs SYSTEM_FLAGS, 372
− Outputs SYSTEM_FLAGS, 373
Systembus (CAN). Siehe manual "System bus (CAN) for
Lenze PLC devices"
T
Table of attributes, 431
Technical data, 40
− current characteristics
application example, 46
device protection by current derating, 47
rated output current, 44
− external brake resistor
type ERBD..., 462
type ERBM..., 462
type ERBS..., 463
− general electrical data, 41
− rated data, 42 , 43
− standards and operating conditions, 40
Telegram counter CAN, 178
Temperature, 40
Temperature inside the controller, monitoring functions,
209
Temporary codes, 380
Terminal extension 9374IB, 375
Terminology used, 15
Thermal monitoring, motor, Sensorless, 32
Thermal sensors, monitoring functions, 210
Thermal separation, 51
Tightening torques
− Control connections, 64 , 77
− control connections, 62
Time monitoring, AIF interface, 192
Time−out monitoring for activated remote
parameterisation, 204
Timeout with activated remote parameterisation, CAN
interface, 204
Torque, safe torque off, 80
Torque control, with speed limitation, 359
Torque limitation, 356
Torque setpoint , 355
Touch probe, 336
− configuring, 336
Touch probe (TP), 364
− function, 364
− sequence, 365
Transfer function master frequency input, 334
Transfer of status/control word, DCTRL (device control),
329
Transmission cable, specification, 91
TRIP, 197
To Next Page
Loading...
Need help?
General
