Lenze ECSEM Series User Manual

Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Description of the function keys
7

194
EDBCSXM064 EN 11.0
7.3.3 Description of the function keys
 Note!
Key combinations with :
Press  and keep it pressed, then press second key in addition.
Key
Function
Menu level
1)
Code level Parameter level Operating level

Change to parameter
level
Change to operating
level
Change to code level
 
Load predefined
configurations in the
menu "Short setup"
2)
Accept parameters
when SHPRG % or
SHPRG is displayed
&
'
Change between menu
items
Change code number
Change figure over
cursor
 &
 '
Quick change between
menu items
Quick change of code
number
Quick change of figure
over cursor
(
Change between main menu, submenus and
code level
Cursor to the right
) Cursor to the left
* Cancel function of + key, the LED in the key goes out.
+
Inhibit the controller, LED in the key lights up.
Reset fault (TRIP reset): 1. Remove cause of malfunction
2. Press +
3. Press *
1)
No menu for ECSxE power supply module
2)
Only active when operating Lenze devices of the 8200 vector or 8200 motec series.

Lenze ECSEM Series Specifications

General

Brand	Lenze
Model	ECSEM Series
Category	Control Unit
Language	English