Configuration
Configuring MotionBus/system bus (CAN)
Individual addressing
8
202
EDBCSXM064 EN 11.0
IMPORTANTPossible settingsCode
SelectionLenze/
{Appl.}
DesignationNo.
C0354 Alternative node address for
CAN_IN/CAN_OUT (CAN bus
interface X4)
201
1 CAN addr. 129 1 {1} 512 Address 2 CAN1_IN
2 CAN addr. 1 Address 2 CAN1_OUT
3 CAN addr. 257 Address 2 CAN2_IN
4 CAN addr. 258 Address 2 CAN2_OUT
5 CAN addr. 385 Address 2 CAN3_IN
6 CAN addr. 386 Address 2 CAN3_OUT
Save changes with C0003 = 1.
The settings are only accepted after carrying out one of the following actions:
ƒ Renewed switch−on of the 24 V low−voltage supply
ƒ Reset node via the bus system (by the network management (NMT))
ƒ Reset node with C0358 = 1
Note!
If reset node is executed via GDC, communication will be interrupted. You
therefore have to log in again manually or find the devices connected to the
bus once again (fieldbus scan).
To Next Page
Loading...
Need help?
General
