Lenze · E84AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 10/2013 · TD17 101
12 Error messages
12.3 CIP™ error messages
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
12.3 CIP™ error messages
Error code
[hex]
Error designation Description
0x000 SUCCESS No error
0x001 . . . Instance error messages
( 136) des Connection Manager
Object (6 / 0x06) ( 135)
0x002 RESOURCE_UNAVAILABLE Resource required to perform the service not available.
0x003 INVALID_PARAM_VALUE Invalid parameter value
0x008 SERVICE_NOT_SUPP Service is not supported.
0x009 INVALID_ATTRIB_VALUE Invalid attribute.
0x00B ALREADY_IN_STATE The object is already in the required state.
0x00C OBJ_STATE_CONFLICT The object cannot perform the service.
0x00E ATTR_NOT_SETTABLE The attribute is write-protected.
0x00F PRIVILEGE_VIOLATION Access denied.
0x010 DEVICE_STATE_CONFLICT The current state of the device prohibits performing the
requested service.
0x011 REPLY_DATA_TOO_LARGE The response data are longer than the response buffer
0x013 NOT_ENOUGH_DATA The data length is too short.
0x014 ATTRIBUTE_NOT_SUPP The attribute is not supported.
0x015 TOO_MUCH_DATA The data length is too long.
0x016 OBJECT_DOES_NOT_EXIST The object is not supported by the adapter.
0x017 FRAGMENTATION The fragmentation for the requested service is currently not
activated.
0x020 INVALID_PARAMETER Invalid parameter
To Next Page
Loading...
