Lenze EtherNet/IP 8400

Lenze · E84AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 10/2013 · TD17 43
6 Commissioning
6.4 Setting the IP configuration of the Inverter Drive 8400
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6.4.1 Setting via the EtherNet/IP configurator of the »Engineer«
 How to set the IP parameters via the EtherNet/IP configurator:
1. Execute the menu command Online  PROFINET /EtherNet/IP configurator addresses ....
The "Assign IP addresses" dialog window is opened and all Lenze EtherNet/IP nodes
connected are listed.
 Note!
• Changes in the IP parameters will become effective immediately.
• An already existing IP connection to the Inverter Drive 8400 is interrupted.