Lenze EtherNet/IP 8400 - Page 87

Lenze · E84AYCEO communication module (EtherNet/IP™) · Communication Manual · DMS 3.0 EN · 10/2013 · TD17 87
9 Parameter data transfer (explicit messages)
9.2 Read parameters
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
For every "explicit message", the path for sending the message via the Ethernet port of the PLC to
the IP address of the drive needs to be set under the Communication tab. This path depends on the
PLC used.
If you need assistance with the setting of this path, please consult the PLC manufacturer.