EasyManua.ls Logo

Lenze i550 Series - Technical Data; Standards and Operating Conditions; Conformities;Approvals; Protection of Persons and Device Protection

Lenze i550 Series
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical data
Standards and operang condions
Conformies/approvals
Conformity
CE 2014/35/EU Low-Voltage Direcve
CE 2014/30/EU EMC Direcve (reference: CE-typical drive system)
EAC TR CU 004/2011 Eurasian conformity: safety of low voltage equipment
EAC TR CU 020/2011 Eurasian conformity: electromagnec compability of technical
means
RoHS 2011/65/EU Restricons for the use of specic hazardous materials in electric
and electronic devices
Approval
UL UL 61800-5-1 for USA and Canada (requirements of the CSA 22.2 No. 274)
UL UL 61800-5-1 File No. E132659
Protecon of persons and device protecon
Enclosure
IP20 EN 60529 Informaon applies to the mounted and ready-for-use state and
not to the wire range of the terminals
NEMA 250 Protecon against contact only according to type 1
Open type Only in UL-approved systems
Leakage current
> 3.5 mA AC, > 10 mA DC EN 61800-5-1 Observe regulaons and safety instrucons!
Starng current
≤ 3 x rated mains current
Insulaon resistance
Overvoltage category III EN 61800-5-1 0 … 2000 m a.m.s.l.
Overvoltage category II EN 61800-5-1 above 2000 m a.m.s.l.
Control circuit isolaon
Safe mains isolaon by double/reinforced insu-
laon
EN 61800-5-1
Protecve measures against
Short circuit
earth fault Earth fault strength depends on the operang status
Overvoltage
Motor stalling
Motor overtemperature PTC or thermal contact, I²xt monitoring
EMC data
Noise emission
Category C1 EN 61800-3 see rated data
Category C2 EN 61800-3 see rated data
Category C3 EN 61800-3 see rated data
Noise immunity
Meets requirement in compliance with EN 61800-3
Actuaon on public supply systems
Implement measures to limit the radio interfer-
ence to be expected:
The machine or plant manufacturer is responsible for compliance
with the requirements for the machine/plant!
< 1 kW: with mains choke EN 61000-3-2
> 1 kW at mains current ≤ 16 A: without addi-
onal measures
EN 61000-3-2
Mains current > 16 A: with mains choke or
mains lter, when sizing for rated power.
EN 61000-3-12
Technical data
EMC data
73

Table of Contents

Other manuals for Lenze i550 Series

Related product manuals