E94AYCEN communication manual (Ethernet)
Commissioning
Configuring the communication module
28 L EDS94AYCEN EN 9.0 - 09/2012
6.2.1 Setting the address
Clicking the Change button in the Settings tab (Fig. [6-1]
) opens the "Configure IP address"
dialog window:
[6-2] Setting the address
In the input fields for the IP address, the subnet mask and the standard gateway, you can
directly set the addresses.
Setting the standard device code C00002 to "101: bind/unbind" or "102: bind/unbind"
copies the values and writes them to the corresponding codes:
The codes can also be set via the parameter list of the Servo Drive 9400 (All parameters
tab).
Tip!
You can use a ping command in the MS-DOS input window to test whether the
entered IP address is valid or not.
Parameter Code
for slot MXI1 for slot MXI2
IP address C13000/1...4
C14000/1...4
Subnet mask C13001/1...4 C14001/1...4
Standard gateway C13002/1...4 C14002/1...4
To Next Page
Loading...
