Appendix
Consistent parameter data
11
88
EDS82ZAFPC010 EN 4.0
Configuring consistent data
Consistency is achieved by an appropriate PROFIBUS master configuration. Please refer to
the corresponding documentation for your configuring software for this purpose.
Tip!
Consistency configuration depends on the PROFIBUS master configuring
software. When using a Siemens−S5 PLC, please consider:
ƒ Consistency is switched on by any word in the consistent area
ƒ Consistency must be switched off by a specific switch−off word.
ƒ The type of CPU and consistency and the address area determine which
word switches off consistency.
To Next Page
Loading...
Need help?
General
