What to do if the decode LED is red on Leuze Valve Positioners?
If the Decode LED on your Leuze Valve Positioner shows a continuous red light, it means the position data is invalid, potentially because it's out of tape. To resolve this, inspect the positioning of the bar code tape, try adjusting the angle of the scanning beam by tilting the BPS 8, verify the mounting, and ensure the BPS 8 window is clean.
Why am I getting a position error with Leuze Valve Positioners?
If you are experiencing a position error with your Leuze Valve Positioner, it could be due to several reasons: the absence of a bar code tape, the scanner being positioned in total reflection, or improper mounting of the scanner. To address this, verify the positioning of the bar code tape, adjust the scanning beam's angle by tilting the BPS 8, ensure correct mounting, and clean the BPS 8 window.
What to do if the status LED is red and flashing on Leuze Valve Positioners?
If the status LED on your Leuze Valve Positioner is flashing red, it indicates a warning. You should query the diagnostic data to determine the specific issue and then take the necessary corrective actions.
How to reset orange flashing status LED on Leuze Valve Positioners?
If the status LED on your Leuze Valve Positioner is continuously orange and flashing, it signifies that a service operation is currently active. You can reset this service operation by using the BPS Configuration Tool.
General| Operating voltage | 10 - 30 V DC |
|---|---|
| Voltage type | DC |
| Current consumption, max. | 50 mA |
| Switching element | Transistor |
| Degree of protection | IP 67 |
| Output current | 100 mA |
| Protection class | III |
| Switching output | PNP |
| Light source | LED |
| Connection | M12 plug |
| Housing material | Plastic |
| Sensing range | 8 mm |
| Type of measurement | Optical |
| Protection circuit | Reverse polarity protection |
| Certifications | CE |
To Next Page
