the selected devices one by one.
Click on this button will open the web browsers to link to
all the selected devices. (One browser per device)
Function buttons
Click on this button to modify the settings of the selected devices.
For more detail, please refer to 0 Setup.
Click on this button to upgrade the firmware of the selected
devices. For more detail, please refer to 0 Upgrade.
Click on this button to reset the selected devices to default
settings.
Click on this button to close the Installation Wizard.
Click on this button to get information about the Installation
Wizard.
Setup
When you select one or multiple devices (of the same model) , the “Setup”
button will be enabled. Click on it to modify the settings of the selected
device(s). After clicking on the “Setup” button, Installation Wizard will try to
connect to the selected device(s). If the authentication is failed, it will popup
a dialog) to ask for correct password and http port number.
The default password is the MAC address of your own FCS-1030, which marks
To Next Page
Loading...
Need help?
General
