address. If you select more than one device, changing the IP address is not
allowed and the IP address field will be disabled.
Basic Network Settings
You can setup the network setting by this page. Usually this is no need to be
changed, if you do change it please make sure you input the correct setting or
the device may not be reachable.
Upgrade
When you select one device or multiple devices (of the same model), the
“Upgrade” button will be enabled. Click on it to upgrade the firmware of the
selected device(s). After click on the “Upgrade” button, Installation Wizard
will try to connect the selected device(s). If the authentication is failed, it will
popup a dialog to ask for the correct password and http port number.
The default password is the MAC address of your own FCS-1030, which marks
at the bottom label of each device.
Please enter the MAC address with capital letters.
Device Information
After connected to the selected device, it will display.
To Next Page
Loading...
Need help?
General
