36
Trap Option
Warm Start
A Warm Start SNMP trap signifies that the SNMP device, i.e. IP Camera,
performs software reload.
Click on <Save> button when complete.
7.2.3.4 UPnP
The UPnP setting can be found under this path: System> Network> UPnP.
UPnP Setting
Enable UPnP
When the UPnP is enabled, whenever the IP Camera is presented to the
LAN, the icon of the connected IP Cameras will appear in My Network
Places to allow for direct access.
NOTE: To enable this function, please make sure the UPnP
component is installed on your computer. Please refer to Install
UPnP components for UPnP component installation procedure.
Enable UPnP port forwarding
When the UPnP port forwarding is enabled, the IP Camera is allowed to
open the web server port on the router automatically.
NOTE: To enable this function, please make sure that your
router supports UPnP and it is activated.
Friendly name
Set the name for the IP Camera for identity.
To Next Page
Loading...
