11 11
Hardware Reset
The Reset Button can be used to reboot the camera or restore it to factory default settings.
If the camera experiences a problem, rebooting the camera may correct the problem. If
the problem remains, please restore the camera to factory default settings and reinstall the
software.
To Reboot - Press and hold the Reset Button for one second using a paper clip or thin
object. Wait for the camera to reboot.
To Restore – Press and hold the Reset Button for ten seconds until the LED light turns off.
When successful restored, the LED will be blue during normal operation.
Note - By restoring the camera, all settings will be restored to the factory default
settings.
USB port also support LevelOne WiFi Dongle (*) and SD/SDHC Pen-drive (*)
1) it supports LevelOne wireless outdoor USB dongle (WUA-5600)
2) it supports SD/SDHC Pen-drive (Maximum 32GB)
(*) Please check with your distributor whether supported by camera.
To Next Page
Loading...
