7
3. Device Appearance Description
3.1 Front & Rear view
The reset button is used to reset the system or restore the factory default settings. Sometimes
resetting the system can return the camera to normal operation. If the problems remain after reset,
please restore the factory settings and install it again.
Reboot - Please press and release the indented reset button within 1 second with paper clip or thin
object. Wait for the network camera to reboot.
Restore - Please press and hold the reset button until the status of LED turns off. It takes about 10
seconds.
3.2 Micro-SD Card Capacity
The network camera is compliant with Micro-SD/SDHC (Maximum 32GB) cards.
To Next Page
Loading...
