Chapter 3 Basic Settings Page 30
Basic Setting
Profile Name: Name of the VAP profile
Wireless Network Name: Enter the virtual SSID for the VAP
Broadcast SSID: In AP mode, hiding network name is necessary when you are in a wireless
environment that may have potential risk. By disabling broadcast SSID, the STA cannot scan and
find the LEVELONE 150MBPS WIRELESS POE AP, so that malicious attack by some illegal STA
could be avoided.
Wireless Separation: Wireless separation is an ideal way to enhance the security of network
transmission. Under the mode except wireless client mode, enable “Wireless Separation” can
prevent the communication among associated wireless clients.
WMM Support: WMM (Wi-Fi Multimedia) is a subset of 802.11e. It allows wireless communication
to define a priority limit on the basis of data type under AP mode only, thus those time-sensitive
data, like video/audio data, may own a higher priority than common one. To enable WMM, the
wireless client should also support it
Max. Station Number: By checking the “Max. Station Num” the CPE will only allow up to 32
wireless clients to associate with for better bandwidth for each client. By disabling the checkbox
the CPE will allow up to 128 clients to connect, but it is likely to cause network congestion or poor
performance.
Security Setting:
To prevent unauthorized radios from accessing data transmitting over the connectivity, the
LEVELONE 150MBPS WIRELESS POE AP provides you with rock solid security settings. For
detailed information please go to Chapter 4 Wireless Security Setting.
VLAN Tab
If your network uses VLANs, you can assign one SSID to a VLAN, and client devices using the SSID are
grouped in that VLAN.
To allow users on the VLAN to access the WEB page of the
LEVELONE 150MBPS WIRELESS POE AP,
you need to enable “Enable 802.1Q VLAN” and assign a management VLAN ID for your device.
Make sure the assigned management VLAN ID is identical to your network VLAN ID to avoid failures
To Next Page
Loading...
