User Manual for BPS-200
www.levitronix.com
PL-4012-00, Rev07, DCO# 20-144
9 Appendix
9.1 Regulatory Status
9.1.1 CE Marking
The Centrifugal Pump System Family BPS-200, in its configurations as listed below is in conformity with the below
mentioned European Directives. The various configurations of the pump system are thought to be used in hydraulic
circuits of industrial production equipment of the Semiconductor, Chemical, Life Science (Biotech, Pharmaceuticals) and
other machinery markets.
Pump casing configurations consisting of variations
concerning fittings, O-Rings, wet materials and performance
and impellers with various materials and
performance variations
Bearingless motors: BSM-1.x (x = various cable, connector and coating options)
Controllers with 24 – 48V DC inputs: LPC-200.x (x = various interfacing options)
Motor controller adaptor cables of various length, air cooling module and others
Machinery Directive 2006/42/EC:
The machinery directive essentially has been followed by a risk analysis, according mitigation actions and a user manual
for safe operation. For the design and testing the following standards are used as a guideline:
Pumps for Fluids: basic requirements are followed.
Procedure for hydrostatic pressure testing in fluid pumps: used for max. pressure testing of pump head.
Safety for machinery principles for risk assessments: used for system risk analysis.
EMC Directive 2014/30/EC:
The following standards of the EMC directive are tested and confirmed at a certified laboratory:
Generic standards, Immunity for industrial environments
Generic standards, Emission standard for industrial environments
9.1.2 Disposal of Equipment – WEEE Directive 2012/19/EU
Follow local legislation for disposal of equipment. In the European Union (EU) marked ( ) devices are governed by the
European WEEE Directive 2012/19/EU. Do not dispose with normal waste.
9.1.3 IECEE CB Safety Certification
Specific motors with pump heads and controllers of the Centrifugal Pump System BPS-200 are 3
rd
party
tested and certified by Electrosuisse following the IECEE CB Scheme according to the following safety
standards:
Safety requirements for electrical equipment for measurement, control and laboratory use.
The CB certification number is CH-7695.
9.1.4 NRTL/ETL Safety Certification and Marking
Specific motors with pump heads and controllers of the Centrifugal Pump System BPS-200 are tested by
the US national recognized laboratory (NRTL) Intertek according to the following safety standards:
Safety requirements for electrical equipment for measurement, control and laboratory (US Standard).
Safety requirements for electrical equipment for measurement, control and laboratory use (Canadian Standard).
Rotating Electrical Machines - General Requirements (US standard).
The ETL control number for the listing is 4010272.
To Next Page
Loading...
Need help?
General
