Lexicon 960L - Page 28

3-6
Basic Operation Lexicon, Inc.
If you selected a clock rate of 88.2 or 96 kHz, you’ll get a
screen as shown in Fig. 3-4 which gives you a choice of six
processing configurations:
1) Stereo In and Out, using one or two machines.
2) One machine, with 5- channels In and 5-Out.
3) One machine, with 2- channels In and 5-Out.
4) One machine, with 4-In / 4-Out.
5) A single 8-In / 8-Out machine, with a pass-through
algorithm, which performs no processing, but is
useful for wiring checkout and diagnostics.
6) Two Mono In / Stereo Out machine.
To select a configuration, enter its number with the
Numeric Keypad (or scroll to it with the Navigation Arrows
and press ENTER).
DSP INPUTS
To select individual DSP inputs from the available cascade
and physical inputs on the 960L, use the navigation arrows
to position yourself on any of the input selection boxes. The
top row of boxes selects the input type and the second
row selects the channel from the selected input type. Use
the Increment/Decrement (+/-) keys to cycle through the
available selections or use the numeric keypad for direct
entry.
Note:
Cascade inputs are only available when two DSP
cards are installed in the 960L. Cascade inputs are
the outputs of the other DSP card.
DSP OUTPUTS
To select individual DSP outputs from the available physi-
cal outputs on the 960L, use the Navigation Arrows to posi-
tion yourself on any of the output selection boxes. The top
row of boxes selects the output type and the second row
selects the channel from the selected output type. Use the
Increment/Decrement (+/-) buttons to cycle through the
available selections or use the Numeric Keypad for direct
entry.
Figure 3-4 — Configuration screen for 88.2/96 kHz clock rate (stereo in/out selected, two machines available)
Input Type
Input Channel of Selected Type