4-15
Operations in Detail960L
EDITING
The 960L Programs and Registers can be edited in several
ways:
• Changing the settings of the parameters with the
faders and joystick.
• Adjusting input and output panning.
• Adjusting input and output levels.
• Assigning new parameters to any fader or to
either joystick axis.
Edits stay in effect until a new Program or Register is
loaded, or can be saved as Registers. You cannot over-
write factory Programs, but you can save edited Programs
as Registers. Registers, like Programs, reside on disk and
can be recalled anytime. They can also be saved on flop-
py disk, for archiving or for copying to a second 960L.
Editing Algorithms
A Program or Register becomes edited any time you alter
the current parameter settings with the faders or joystick.
To save these—or any other—edits, just press the STORE
key. Check to be sure the storage location is correct, then
press STORE again.
Editing With the Faders
1) Use the Numeric Keypad or Navigation Arrows to
select the Edit page that contains the parameter
you want to change.
2) Check the Scribble Strip to find the parameter to
edit.
3) Touch the corresponding fader. That parameter
will be highlighted on the Scribble Strip and its
name and setting will appear in large characters
on the Action Display at the upper left of the
screen.
4) Adjust the fader to the desired setting.
Fine Adjust
For some parameters, the range of possible values is so
large that the smallest possible fader movements change
the value too much.
To make fine adjustments, set the faders to the approxi-
mate values you want, then press the FINE ADJ button.
When this button is pressed, the faders all move to the
center of their travel, but their parameter settings do not
change. The faders then operate in a vernier mode, with
a limited adjustment range and far fewer steps per inch of
travel, so that full-range movement of the fader will alter
the parameter value only a little from its coarse value. This
makes it easy to tweak the setting to the exact value you
want.
On entering Fine Adjust mode, the Action Display says
"Fine Adjust Enabled". The centering of all faders is an
additional indication.
Pressing FINE ADJ a second time will return the system to
normal operation. The faders will return to their appropri-
ate full-range positions.
When in the Edit Algorithm mode, to make fine adjust-
ments of a single parameter, simply touch the appropriate
fader to select the parameter, then use the
Increment/Decrement (+/–) keys to get the setting you
want. Each press of these keys will change the parameter
by its smallest possible increment.
Figure 4-30 — Algorithm Edit Screen with one fader parameter selected
To Next Page
Loading...
Need help?
General
