Lexicon 960L User Manual

3-8
Basic Operation Lexicon, Inc.
(4) Editing a Program or Register
Once a Program or Register is loaded, you can edit it to
get exactly the effect you want. The simplest way to do
this is by changing the settings of the parameters assigned
to the faders and joystick on the V-Page, which is avail-
able in Program, Register and Bank modes.
For parameters assigned to faders:
• Touch the fader you want to change. When you
do, that parameter and its setting will be high-
lighted in yellow on the Scribble Strip and will
appear, in larger lettering, on the Action Display.
Move the fader to get the desired setting.
• If you can’t move the fader in small enough incre-
ments to get the precise setting you need, get as
close to that setting as you can, then press the
FINE ADJ key and adjust the parameter with the
fader in vernier mode. Press FINE ADJ again to
leave Fine Adjust mode.
• You can move several faders at once. The settings
indicated on the Scribble Strip will change for all.
When you release the faders, the last one you
touched will be highlighted and appear on the
Action Display.
For parameters assigned to the joystick:
• P ress the JOYSTICK key on the LARC2, then
adjust the joystick until the Joystick Status Display
shows the desired settings (Fig. 3-6).
(5) Storing Your Edits
Your edits will stay in force
until you change them again
or load another Program or
Register. To save them for
future use, press the STORE
key. The STORE key will blink
to remind you that the Store
operation is pending.
• If you’ve been editing a user-created Register, the
960L will highlight the current Bank and Register. If
you wish to replace that Register with your edited
version, press STORE a second time to save your
edit.
• If you've been editing a factory Program, the 960L
will look for the first Register Bank with space avail-
able or the Register Bank you last stored to, and
the first empty Register within that bank.
• If you’d prefer a different Register Bank, press the
BANK key and enter the number of the desired
bank (or scroll to it with the Navigation Arrows).
• If you'd prefer a different Register, press the REGIS-
TER key and enter the number of the desired
Register (or scroll to it with the Navigation Arrows).
• To name a Register or Register Bank, press the
NAME soft button and follow the directions below.
• To add explanatory information to a Register or
Register Bank, press the INFO soft button and fol-
low the directions below.
• When everything (target Bank, target Register,
NAME and INFO) is the way you want it, press
STORE again to save.
Figure 3-6 —
Joystick Status Display
Figure 3-7 — Storing

Lexicon 960L Specifications

General

Brand	Lexicon
Model	960L
Category	Recording Equipment
Language	English