Basic Operation Lexicon, Inc.
A QUICK GUIDE TO OPERATION
Basically, using the 960L involves only the following:
1) Setting up the system for the job.
2) Selecting a machine.
3) Loading the Programs and Registers you want.
4) Editing the Program or Register parameters with
the faders and joystick.
5) Storing your edits for quick recall at any time.
To make this overview as clear as possible, only one screen
will be shown per operation. In practice, you may see
slightly different screens depending on the selections you
make. These are discussed further in Section 4, Operations
in Detail.
(1) Setup (Control Mode)
Press the CONTROL key and then the WORDCLK Soft
Button on the LARC2 control surface, to bring up the
screen shown in Fig. 3-2.
You can tell Fig. 3-2 is in Word Clock mode by the red high-
light around the WORDCLK soft button. You can tell that
Source Selection is the active control because its name
(SOURCE) has a blue background. The name of the inac-
tive control (RATE) has a yellow background. If the RATE
control was active, pressing the Left Arrow would activate
SOURCE.
• Press the number on Numeric Keypad for the
clock source you want. (Refer to Chapter 4,
Operations in Detail, to find out more about clock
sources.)
• Use the Right Arrow to move to the RATE display.
• Press the number corresponding to the sample
rate you want.
Note:
A small padlock symbol in the System Status
Display shows whether the 960L is locked to
the clock source. If the 960L is not locked to the
selected clock source, the padlock box will
blink red and the 960L will mute until lock is
established.
Figure 3-2 — Control mode, Word Clock selection
To Next Page
Loading...
Need help?
General
