1-7
Product Overview
Setting Output Level
1. Press System and select the Audio menu.
2. Scroll to Audio Output and select Analog or Digital.
3. Press System again and select the Modes menu.
4. Scroll to Modes: Bypass and make sure that the assignment is Bypass (the
default setting).
5. Press the front panel Bypass button. The button will light to indicate that
bypass is engaged.
6. Press Edit, scroll to Meters Assign and select Output.
7. Run audio through the unit and use the front panel Output knob to set the
level on your console or amplifier.
The signal level from the 1/4" and XLR outputs is +4dBu. If you have both 1/4"
and XLR cables attached to the output connectors, there will be no change in
level unless you are driving very low impedance loads (600Ω), where an
attenuation of output level may occur.
To Next Page
Loading...
Need help?
General
