2-12 Service Manual
5026
80 Fuser Life Warning • Select Continue to clear the message and continue printing.
• Show Me, View Supplies, and Tell Me More displays additional information.
• Order a replacement fuser. When print quality is reduced, install the new fuser using the
instruction sheet that comes with the replacement fuser.
Note: Be sure to reset the fuser count. See “Reset Fuser Cnt” on page 3-25.
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-139.
80 Replace Fuser • Show Me, View Supplies, and Tell Me More displays additional information.
• Replace the fuser. See “Fuser removal” on page 4-90.
Note: Be sure to reset the fuser count. See “Reset Fuser Cnt” on page 3-25.
•
• If this does not fix the problem, replace the system board. See “System board removal”
on page 4-139.
80 Fuser Missing • Reinstall the fuser. See “Fuser removal” on page 4-90.
• Reseat connectors behind fuser. They may get dislodged and not make good contact
when the fuser is installed.
• Check the cable connectors for damage at the system board and at the LVPS.
80.41 Fuser missing • Install the fuser. Replace the fuser if the problem persists.
• If the problem continues, turn the printer off and remove the rear frame cover. See “Rear
frame cover removal” on page 4-33. Check the cable in connector JFUSER1 (A) for
proper connection to the system board, the cable for pinch points, and the cable or the
connector for any other damage. If the connector is damaged on system board, replace
the system board. See “System board removal” on page 4-139. If the fuser cable is
damaged, replace the cable.
• Check for the following continuity between the DC autoconnect and FUSER1.
• If continuity is not present, replace the fuser cable. If the problem persists after replacing
cable, replace the system board. See “System board removal” on page 4-139.
82 Waste Toner
Nearly Full
• Select Continue to clear the message and continue printing.
• If printing continues, order a replacement waste toner box immediately.
• If the problem persists, open the front access door and check the aligner shaft for binding.
Clear the binding if possible. If not possible, contact your next level of service.
Error code Action
1
JSB1
JBIN1
JFAN1
JFUSER1JFUSER1
JBOR1
JHVPS1JHVPS1
JMIRR1
JBLW1
JCVR1
JLVPS2
JCARTP1
JCARTS1
JCARTS2
JCARTP2
JDVR1
JTPS1
JOPT1
JFDS1
JINT1
JFDPCK1JTRAY1JSEC1
JDX1
JT12JT12
J5
JDIMM1
JOPP1
JT1
JUSB1JUSB1
JBOOT1
JFMUSB1JFMUSB1
J49
JTWF1
JTDBUG1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
JTLBT1
JPH1
F5
F6
F7
F9
F10
F12
F13
F14F14
1
1
J10
1
1
A
AC auto-
connect
DC auto-
connect
Pin 1 Pin 3
Pin 5 Pin 4
Pin 6
Pin 7
Pin 8
Pin 9
Pin 10
To Next Page
Loading...
