Diagnostic information 2-13
5026
82 Replace Waste
Toner
• Replace the waste toner box using the instruction sheet that comes with the replacement
waste toner box.
• Ensure that there is no interference between the waste toner box and the printer.
• If the problem persists, open the front access door and check the aligner shaft for binding.
Clear the binding if possible.
• If the problem persists, replace the system board. See “System board removal” on
page 4-139.
• If the problem persists, contact your next level of service.
82 Waste Toner Missing • Insert the waste toner box.
• Inspect the top cover camshaft assembly for proper operation. When the top access
cover is closed, the printer should mechanically interlock.
• Check the cable in connector JBUMP1on the system board for defects and proper
connection. If the cable wiring or the cable connection is defective, replace the bump
multipurpose feeder/duplex motor assembly. See “Multipurpose feeder (MPF)/duplex
motor assembly removal” on page 4-104. If the cable in JBUMP1 connector is
damaged on the system board, replace the system board. See “System board removal”
on page 4-139.
• Check the aligner shaft and the mechanical system for binds.
• Replace the bump multipurpose feeder/duplex motor assembly. See “Multipurpose
feeder (MPF)/duplex motor assembly removal” on page 4-104.
• If the problem persists, replace the system board. See “System board removal” on
page 4-139.
82.41 If you continuously get this error, then the problem is the aligner motor error. Go to “147.xx,
920.01—Aligner motor error service check” on page 2-50.
83.xx Transfer Module
Life Warning
• Select Continue to clear the message and continue printing.
• Order a replacement transfer module. When print quality is reduced, install the new
transfer module using the instruction sheet that comes with the replacement transfer
module.
• If the problem persists, replace the system board. See “System board removal” on
page 4-139.
83.xx Replace Transfer
Module
• Replace the transfer module using the instruction sheet that comes with the replacement
transfer module. See “Transfer module removal” on page 4-154.
• If the problem persists, replace the system board. See “System board removal” on
page 4-139.
83.41 Transfer Module
Missing
If the you continuously get this error, go to “920.03, 920.25—Transfer Module Missing
error service check” on page 2-92.
84.11 <color> PC Unit
Life Warning
• Select Ignore to clear the message and continue printing.
• Order the specified photoconductor unit. When print quality is reduced, install the new
specified photoconductor unit using the instruction sheet that comes with the replacement
specified photoconductor unit.
• If the problem persists, replace the system board. See “System board removal” on
page 4-139.
84 Replace <color> PC
Unit
• Replace the specified photoconductor unit using the instruction sheet that comes with the
replacement specified photoconductor unit.
• If the problem persists, replace the system board. See “System board removal” on
page 4-139.
Error code Action
To Next Page
Loading...
