Security Audit Log menu
Menu item Description
Export Log Enables an authorized user to export the audit log
Notes:
• To export the audit log from the printer control panel, a flash drive must be
attached to the printer.
• From the Embedded Web Server, the audit log can be downloaded to a
computer.
Delete Log
Yes
No
Specifies whether audit logs are deleted
Note: “Yes” is the factory default setting.
Configure Log
Enable Audit
No
Yes
Enable Remote Syslog
No
Yes
Remote Syslog Facility
0–23
Severity of events to log
0–7
Specifies whether and how audit logs are created
Notes:
• Enable Audit determines if events are recorded in the secure audit log and
remote syslog. No is the factory default setting.
• Enable Remote Syslog determines if logs are sent to a remote server. No is the
factory default setting.
• Remote Syslog Facility determines the value used to send logs to the remote
syslog server. 4 is the factory default setting.
• With the security audit log activated, the severity value of each event is
recorded. 4 is the factory default setting.
Set Date and Time menu
Menu item Description
Current Date and Time Shows the current date and time settings for the printer
Manually Set Date and Time
[input date/time]
Notes:
• Date and Time is set in YYYY-MM-DD HH:MM format.
• Manually setting the date and time sets Enable NTP to Off.
Time Zone
[list of time zones]
Note: GMT is the factory default setting.
Automatically observe DST
On
Off
Note: On is the factory default setting. This uses the applicable Daylight Saving
Time associated with the Time Zone setting.
Enable NTP
On
Off
Enables Network Time Protocol, which synchronizes the clocks of devices on a
network
Notes:
• On is the factory default setting.
• The setting is turned off if you manually set the date and time.
Understanding the printer menus 115
To Next Page
Loading...
Need help?
General
