Media specifications
Labels Width: 140–320 mm (5.5–12.6 in.)
Length: 182–457 mm (7.2–18 in.)
Weight:
60–256 g/m
2
Smoothness: 100–200 Sheffield
Card stock Width: 140–320 mm (5.5–12.6 in.)
Length: 182–457 mm (7.2–18 in.)
Weight:
60–256 g/m
2
Card stock and label guidelines
When printing on labels:
• From the printer control panel, set the paper size, type, texture, and weight in the Paper menu to match the labels
loaded in the tray.
• Do not use label sheets with a slick backing material.
• Do not print within 1 mm (0.04 in.) of the die‑cut, the edge of the label or the perforations, or between the die‑cuts.
• Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial sheets
also contaminate the printer and the cartridge with adhesive, and could void the printer and toner cartridge
warranties.
When printing on card stock:
• From the printer control panel, set the paper size, type, texture, and weight in the Paper menu to match the card
stock loaded in the tray.
• Do not use creased card stock. It may cause paper jams.
• We recommend the use of grain long card stock.
Optra plus, 4039, 4029, 4019, WinWriter 600 printers
The following table lists the maximum weights supported by each of the special card stock and label trays, as well as
the manual feed tray.
Printer specifications 151
To Next Page
Loading...
Need help?
General
