* 150–250 Sheffield is optimal. Using media higher than 300 Sheffield could result in printing degradation.
Card stock Width: 210–216 mm (8.3–8.5 in.)
Length: 279–356 mm (11–11.7 in.)
Weight:
Up to 163 g/m
2
Index Bristol (90 lb)
Card stock and label guidelines
When printing on labels:
• Set the Paper Type to Labels in the Paper Menu.
• Do not use label sheets with a slick backing material.
• Do not print within 1 mm (0.040 in.) of the die-cut, the edge of the label, the perforations, or between the die-cuts.
• Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a paper jam.
• Do not use label sheets that have adhesive to the edge of the sheet. We recommend zone coating of the adhesive
at least 1 mm (0.040 in.) away from the edges. Adhesive material may contaminate your printer and could void
your warranty.
When printing on card stock:
• Set the Paper Type to Plain Paper. The Optra W810 treats card stock the same as Plain Paper. It does not adjust the
print speed or fuser temperature when the Paper Type is set to Card Stock.
• Do not use card stock that is creased. It may cause paper jams.
• We recommend the use of grain long card stock.
Printer specifications 173
To Next Page
Loading...
Need help?
General
