When printing on labels:
• From the printer control panel, set the paper size, type, texture, and weight in the Paper menu to match the labels
loaded in the tray.
• Do not load labels together with paper or transparencies in the same paper tray. Combining print materials can
cause feeding problems.
• Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a paper jam. Adhesive
material may contaminate your printer. It could also void your printer and cartridge warranties.
When feeding labels, the number of labels per sheet can affect registration more than basis weight. Typically, the more
labels per sheet, the better the registration.
When printing on card stock:
• From the printer control panel, set the paper size, type, texture, and weight in the Paper menu to match the card
stock loaded in the tray.
• Do not use card stock that is creased. It may cause paper jams.
For more information, see the following:
• “Pick roller technology” on page 11
• “Grain orientation” on page 17
• “Maintenance procedures” on page 14
• “Troubleshooting” on page 14
• “Primary rib pattern design guidelines for reference edge alignment” on page 22
Printer specifications 88
To Next Page
Loading...
Need help?
General
