Installing optional trays
Note: Depending on your printer model, you may install a 650‑sheet duo tray or both the 650‑sheet duo tray
and 550‑sheet tray.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock, if you are accessing the controller
board or installing optional hardware or memory devices sometime after setting up the printer, then turn
the printer o, and unplug the power cord from the electrical outlet before continuing. If you have any
other devices attached to the printer, then turn them o as well, and unplug any cables going into the
printer.
1 Turn o the printer.
2 Unplug the power cord from the electrical outlet, and then from the printer.
3 Unpack the optional tray, and then remove all packing material.
4 Align the printer with the optional tray, and then lower the printer into place.
CAUTION—POTENTIAL INJURY: If the printer weight is greater than 20 kg (40 lb), then it requires
two or more trained personnel to lift it safely.
Note: If you are installing both the optional trays, then place the 550‑sheet tray below the 650‑sheet duo
tray.
Upgrading and migrating 271
To Next Page
Loading...
