Lexmark MS71x - Supply Life Messaging Information

Lexmark MS71x/MS81x & MX71x/MX81x Product Study Guide Rev 1.3
For Training Purposes Only 11/19/2012
70
Supply Life Messaging Information
Toner Cartridge Life Messaging
The following table provides the messaging that will appear on the control panel as supply life becomes
low. The Controller Board determines when the “Cartridge Low” message occurs; the IU determines
when the “Cartridge Very Low” occurs.
Saved
Warning
1
Default
Setting
2
Toner Level
Default
Rating
3
Behavior Options
4
(Default in Blue)
Control Panel Message
5
Nearly Low
Disabled
6K = 20%
10K = 20%
25K = 10%
45K = 10%
Off
Warning
Email Alert
Continuable Stop
Non-Continuable Stop
"Cartridge nearly low"
Low
Enabled
6K = 10%
10K = 10%
25K = 5%
45K = 5%
Off
Warning
Email Alert
Continuable Stop
Non-Continuable Stop
"Cartridge low"
Near End of
Life
Enabled
6K = 3%
10K = 2%
25K = 1%
45K = 1%
Off
Warning
Email Alert
Continuable Stop
Non-Continuable Stop
"Cartridge very low, 200
estimated pgs remain"
Pages remaining calculated on the
usage of the past 2000 pages
printed
End of Life
Enabled
0%
Non-Continuable Stop
"Replace cartridge, 0 estimated
pgs remain"
1
The generic name of the warning used for Lexmark support documentation.
2
This column indicates whether or not the message is enabled by default.
3
This column indicates the default cartridge life remaining for each cartridges yield type. Once the
cartridge reaches this percentage, it will trigger the given warning. The user can change level that will
trigger the warning. The procedures to do this are documented in this guide in ye section called “How to
Change Supply Life Messaging Settings.”
4
This column lists the default behavior options at each warning notification. The customer can customize
this feature. The default behavior is documented in blue if no change is made.
5
This indicates the actual message that will appear on the product control panel when the warning is
triggered.