101
Set up the optional finisher
CAUTION!
If you are installing the fin-
isher sometime after initial printer setup,
turn the printer off and unplug the power
cord before continuing.
To set up the finisher:
1
Pull the packing box off of the
finisher.
2
Remove the finisher and all
other items from their packing
materials.
Remove any plastic wrapping,
shipping tape, and protective
foam.
Do not remove the hole
punch box on the right side of the
finisher.
Save the carton and packing
materials in case you need to
repack the finisher.
3
Remove the two bags contain-
ing the guide rail bracket, set
pin, magnetic bracket, and
screws from inside the finisher.
4
Make sure you have the follow-
ing items:
— Finisher
— Transport unit
— Support shelf
— Guide rail
— Guide rail bracket
— Set pin
— Magnetic bracket
— 3 screws
If any items are missing or dam-
aged, refer to the registration card
for the designated Lexmark sup-
port phone number for your
country.
Transport unit
Support shelf
Guide rail
Finisher
Guide rail bracket
Set pin, magnetic bracket,
and screws
Hole punch box
Do not remove
To Next Page
Loading...
