Lexmark Optra W810 - Step 14: Set up Network Addresses; Printing a Network Setup Page

155
Set up network addresses
Step 14: Set up network
addresses
Note:
Make sure you always
use the latest version of the
Drivers, MarkVision and Utilities
CD available to you. Visit the
Lexmark Web site for the most
recent software and documenta-
tion updates.
We have provided some helpful hints for setting up your network
addresses. If you need additional setup information or troubleshoot-
ing tips, refer to the documents on the
Drivers, MarkVision and
Utilities
CD. After launching the CD, click
View Documentation
and
then click
MarkNet Print Servers
.
Printing a network
setup page
If you used an internal print server to attach your printer to a network,
use the printer operator panel to print a network setup page. The net-
work setup page shows the physical address, known as the
universally administered address (UAA), of the print server and other
important data.
To print a network setup page:
1
From the operator panel, press
Menu>
to enter the menus.
2
Continue to press and release
Menu>
until you see
UTILI-
TIES MENU
.
3
Press
Select
.
4
P
ress
Menu>
until you see
Print Net1 Setup
(if the print
server is installed in network connector 1) or
Print Net2
Setup
(if the print server is installed in network connector
2).
5
Press
Select
again.
The network setup page prints.